Illinois Reuse Machineries and Industrial Equipment Newsboad > Electrical Components
> New ready welder ii 10000ADP portable mig welding kit
New ready welder ii 10000ADP portable mig welding kit
ALL EQUIPMENT SOLD IS NEW AND IN ORGINAL FACTORY PACKAGING W/ 2 YEAR FACTORY WARRANTY:
The Readywelder RWII Model #10000ADP is cabled for BATTERY operation, MIG (constant voltage) "DC" output machines or ARC/STICK (constant current) "DC" output machines.
This model is most frequently used by repairmen, maintenance workers, 4X4 off-road enthusiasts, ranchers, boaters, agricultural industry, construction and industrial companies and anyone primarily using Batteries, MIG "DC" output machines or ARC/STICK "DC" output machines as the power source.
The ground cable is attached to the red dual quick disconnect connectors. This makes welding jobs in remote locations easy, portable and quick. This model will run off any 12, 18, 24 & 36 volt batteries in a parallel series depending on the application and material to be welded. The Model #10000ADP has a two year 100% parts and labor limited factory warranty.
Welds steel (without) use of shielding gas, using flux core wire.
Welds aluminum, stainless, steel, copper and cast (with) shielding gas, requires correct welding wire, regulator and shielding gas.
Uses standard 4" - 1 lb and 2 lb spools.
12 Volt Battery can do Thin Sheet Metal
Two 12 volt Batteries can also be hooked in series for thicker material
24 Volt will Single Pass 1/2" @275 amps
36 Volt will Weld up to 3/4" @350 to 400 amps
Connects to MIG/Constant Voltage "DC" Output Welders
Connects to ARC-STICK/Constant Current "DC" Output Welders
Uses Wire Sizes from .023 to 3/64 without Changing Rollers
Uses Heavy-Duty Tweco Quality Front End Consumables
Wire Speeds of 50 Inches to 900 Inches per Minute
Built-in Stitch Mode for Thinner Material
Ten Foot Cable with Quick Disconnects, Can be Extended to 100 Feet
Reader Welder II High-Impact MIG Gun
Extra Tips and Gas Hose Fitting
Foam Lined Blow-Molded Tough Briefcase
AC to DC Power converter supply - 24 DC volts to drive gun controls when connected to a ARC/STICK (constant current) DC welder.
