Illinois Reuse Machineries and Industrial Equipment Newsboad > Machine Tools
> Used
> New 7/8 ton ground water source heat pump furnace ac
New 7/8 ton ground water source heat pump furnace ac
CLICK HERE TO SEE ALL OUR GROUND SOURCE HEAT PUMP ITEMS!
THIS IS A NEW 10,000 BTU - 0.833 ( 7/8 IS 0.875) TON WATER SOURCE HEAT PUMP. IT HEATS AND COOLS. CLIMATEMASTER MODEL 81610GSPESLOS. THIS HAS AN AUTOMATIC 2.5 GPM FLOW REGULATOR INSTALLED. 208 / 230 VOLTS SINGLE PHASE. THIS WILL WORK ON THE POWER YOU HAVE IN YOUR HOUSE OR SHOP. NEW, SCRATCH AND DENT SPECIAL HOWEVER! HAD SOME BENT SHEET METAL, I WENT OVER THE UNIT TOP TO BOTTOM AND STRAIGHTENED THINGS OUT A BIT. ALL DAMAGE WAS STRICTLY COSMETIC IN NATURE, WOULD NOT HAMPER THE OPERATION OF THE UNIT ONE BIT.
THESE ARE INTENDED TO SLIDE INTO A UNIT IN THE WALL THAT CONTAINS THE FAN AND THE CONTROLS. THESE UNITS DO NOT HAVE THE CIRCUIT BOARD OR CONTACTORS FOR CONTROL. THEY HAVE THE COIL THE AIR PASSES OVER, THE COMPRESSOR, THE EXPANSION VALVE AND CHANGEOVER VALVE ( THE THING THAT SWITCHES IT BETWEEN HEATING AND COOLING ), THE HEAT / WATER EXCHANGER COIL, AND ALL THE MONITORING SENSORS AND SWITCHES THAT PLUG INTO THE CONTROL BOARD. WE DO NOT HAVE THE MATCHING CABINETS, THEY CAN BE OBTAINED FROM ANY CLIMATEMASTER DEALER. THE EXCHANGER COIL IS NOT INSULATED SO YOU WILL NEED A COUPLE CANS OF EXPANDI FOAM IF YOUR GOING TO RUN GROUND WATER THROUGH IT TO PREVENT ANY POSSIBLE CONDENSATION / SWEATING ON THE WATER COIL.
THESE HAVE WATER METERING DEVICES ON THEM SO THEY ONLY USE WHAT THEY NEED - THIS ONE USES 2.5 GALLONS PER MINUTE. COPPER WATER PIPES CAN BE SOLDERED ONTO OR YOU CAN USE THE CONNECTORS ON THE ENDS.
THIS UNIT IS ROUGHLY 16" WIDE, 16" DEEP AND 37" TALL.
THIS IS A PERFECT OPORTUNITY TO GET ON THE GEOTHERMAL BAND WAGON AND START SAVING SOME MONEY. WHAT OTHER IMPROVEMENT TO YOUR HOME HAVE YOU OR CAN YOU MAKE THAT IS GOING TO SAVE YOU SO MUCH MONEY? THE SAYING IS FOR EVER DOLLAR OF ENERGY YOU PUT INTO THEM YOU GET $5 OF HEAT OUT..... AND THAT WAS BEFORE FUEL PRICES WENT SKY HIGH! YOU CAN EVEN TAKE THESE ONE STEP FURTHER, PURCHASE TWO AND HAVE A TWO STAGE SYSTEM THAT ONLY RUNS WHAT IT NEEDS TO HEAT OR COOL. THAT CAN BE DONE WITH A GOOD THERMOSTAT - ONE THAT HAS TWO STAGES OF HEAT AND TWO OF COOLING.
THESE ARE GOOD SOLID UNITS FOR THE FOLKS THAT ARE OPORTUNITY ORIENTED AND CAN TAKE THE BALL AND RUN WITH IT. IF YOUR NOT THE PUTTERING TYPE A LOCAL HVAC TECHNICIAN CAN MAKE QUICK WORKOF IT, CHECK WITH THEM FOR PRICES AND RATES, WE HAVE NO CLUE.
CLICK HERE FOR THE INSTALLATION / OWNERS MANUAL FOR THIS UNIT.
THE UNIT YOU RECEIVE WILL NOT HAVE THE SAME SERIAL NUMBER AS THE ONE SHOWN HERE. WE HAVE SEVERAL OF THESE, ALL NEW, SO ONE PIC IS DOING IT FOR ALL OF THEM!
Use the "ask seller a question" to contact us with questions or concerns. Please reference Part Number 6201 when you contact us.
